Skip to content

Heat Pump Installation in Burbank, CA

Serving Burbank and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (213) 410-0763

The short answer

A heat pump is a strong fit for most Burbank homes because it handles hot valley summers and mild winters with one system. AdvancedAir Contractors sizes each system to the house, handles the swap from a gas furnace if you have one, and confirms which utility rebates apply to your address before quoting them.

Burbank sits on the eastern edge of the San Fernando Valley, and summers here run much hotter than in neighborhoods near the coast. Winters stay mild. That combination suits a heat pump, a single system that cools in summer and heats in winter. AdvancedAir Contractors installs heat pumps for homes across Burbank, including ZIP codes 91501, 91502, 91504, 91505, and 91506. Our base in Reseda is about 13 miles west, so Burbank is a regular part of our service area. This page covers what to know before replacing an aging furnace and AC with a heat pump: sizing for valley heat, local air rules, rebates, and what installation day looks like.

Why heat pumps fit Burbank's climate

Los Angeles has a Mediterranean climate with dry summers and mild winters, but inland valleys like Burbank get much hotter in summer than coastal areas. Fall Santa Ana winds can also bring hot, dry spells after summer seems to be over. Your cooling system needs to keep up on the hottest afternoons, not just on an average day.

Winters here rarely get cold enough to challenge a modern heat pump. Most Burbank homes can rely on one heat pump for both heating and cooling instead of running a gas furnace for a few months and a separate AC the rest of the year.

Sizing a heat pump for a valley home

An oversized system cycles on and off too often and leaves rooms clammy or uneven. An undersized one runs nonstop on hot days and still falls behind. We size the system to your house, not to the nameplate on the old unit.

Before recommending equipment, we look at the details that drive heating and cooling load in a Burbank home:

  • Square footage, ceiling height, and the number of stories
  • Attic insulation and how well the attic is vented
  • Window size, type, and which way the main windows face
  • Condition and layout of existing ductwork
  • Rooms that run hotter or colder than the rest of the house
  • Where the outdoor unit can go, with clearance and reasonable distance from bedrooms and neighbors

Replacing a gas furnace: local rules to know

Many Burbank homes still heat with a natural-gas central furnace. South Coast AQMD Rule 1111 limits nitrogen oxide emissions from fan-type gas furnaces sold and installed in the Los Angeles region, and the district has been amending the rule toward zero-emission requirements. The district sets and revises the compliance dates, so anyone planning a furnace replacement should check the current version of the rule before deciding.

A heat pump avoids that question because it burns no gas on site. If your furnace is near the end of its life, we can walk you through a full switch to a heat pump, or other options if a full switch doesn't suit your home right now.

Rebates and incentives for Burbank addresses

Rebates depend on which electric utility serves your address. LADWP residential customers can apply for Consumer Rebate Program rebates on qualifying heat pump systems. The amount is based on the unit's SEER2 and HSPF2 ratings, and the application is filed after the equipment is purchased and installed, within 12 months of purchase. Many homes outside the City of Los Angeles are served by a different utility, though, so that program may not apply to your Burbank home. We confirm the current offer for your address before we include it in a quote.

The federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations after that date, so don't plan your budget around it.

What installation looks like

Most heat pump installations follow the same steps. We remove the old furnace, AC condenser, or both, then set the new outdoor unit on a level pad and install the indoor air handler or coil. We run or replace the refrigerant lines, make the electrical connections, and connect the system to your ductwork. Before we leave, we test the system in both heating and cooling modes, set up the thermostat, and show you how to use it.

If your ducts are leaky, undersized, or damaged, we'll tell you before installation and explain what repair would involve. A new heat pump can only perform as well as the ducts that carry its air.

Serving Burbank and nearby cities

Besides Burbank, AdvancedAir Contractors installs heat pumps in Los Angeles, West Hollywood, Beverly Hills, Santa Monica, and San Fernando. If you're comparing options or your current system is struggling, contact us to set up a visit and talk through what makes sense for your home.

More services in Burbank

Related

What to expect

How a visit goes

  1. We find the cause first

    Before we recommend anything, we test the system and track the symptom back to its source. That way you pay to fix the actual problem, not to replace parts until something works.

  2. We explain your options clearly

    You'll hear what we found, what it means for your system, and the choices you have, including whether a repair or a replacement makes more sense for the equipment's age and condition.

  3. We check the local details

    Furnace emissions rules and equipment rebates in Southern California depend on the district and on which utility serves your address. We confirm what currently applies to your home before you make a decision.

FAQ

Common questions

Will a heat pump keep my Burbank home cool during summer heat waves?

Yes, if it's sized correctly. Burbank runs much hotter than coastal areas in summer, so we size the system for your home's real cooling load, including insulation, windows, and sun exposure.

Is a heat pump enough to heat my home in winter?

For most Burbank homes, yes. Winters here are mild, and a properly sized modern heat pump can handle heating without a separate gas furnace.

Can I get the LADWP heat pump rebate in Burbank?

The LADWP Consumer Rebate Program applies only to LADWP residential electric customers. Many homes outside the City of Los Angeles are served by a different utility, so we confirm which utility serves your address and what it currently offers before quoting any rebate.

Is the federal tax credit for heat pumps still available?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025. It doesn't apply to new installations after that date.

Do I need new ductwork for a heat pump?

Not always. Many homes can reuse their existing ducts. We inspect them during the estimate and let you know if leaks, damage, or undersizing would hold the new system back.

Should I replace my gas furnace with another gas furnace or a heat pump?

That depends on your home and plans, but check South Coast AQMD Rule 1111 first. It limits emissions from gas furnaces in the region, and the district has been moving the rule toward zero-emission requirements.

Tell Us What Your System Is Doing

Whether it's warm air from the vents, a furnace that won't stay lit, or a strange noise you can't place, describe the problem and we'll set up a visit to diagnose it and walk you through your options.

Call (213) 410-0763 Request Service